ZETA® Spray Cleaning System Maintenance
Course Length
10 days
Class Size
Maximum of 6 students
Target Audience
Equipment maintenance technicians
Course Prerequisites
Basic knowledge from two years of experience or education:
- Technical degree in an electrical or mechanical field or equivalent experience
- Ability to use a multi-meter to measure AC/DC voltage, current and resistance
- Ability to read schematic prints and understand technical symbols
- Basic understanding of computers and industrial software controls
- Fluency in English
- Chemical safety training in a fab environment
- Understanding of MSDS forms
Course Objectives
Upon the successful completion of the ZETA® System course, the attendee will be able to:
- Resource the FSI equipment operation and maintenance manual, supplementary training package and designated prints
- Perform operational control functions
- Demonstrate how to service the system
- Perform routine troubleshooting procedures
- Perform corrective action and troubleshooting
NOTE: Material Handling Module (MHM) components are not covered in this class. Contact FSI Technical Training at \n This e-mail address is being protected from spambots. You need JavaScript enabled to view it "--> This e-mail address is being protected from spambots. You need JavaScript enabled to view it for information on classes offered for 300mm and 200mm ZETA® System MHM.
Registration and Cancellation Policies
Registration:
- Accepted on a first-come, first-served basis
- Paid via a Purchase Order number, training credits or a combination of both
- Made by calling 952.448.8025, filling out the On-Line Registration Request Form or e-mailing
This e-mail address is being protected from spambots. You need JavaScript enabled to view it
Cancellation:
If cancellation is made by:
- 15 business days: no fee
- 11—15 business days: 25%
- 10 or less business days: 50%
- No cancellation (no show): 100%
Note: A minimum class size of four is required to hold a class. FSI reserves the right to cancel classes that do not meet the minimum size requirement and to reschedule attendees into the next available class. The attendee will be responsible for any costs due to travel arrangement changes/cancellations. Notifications of cancellations/changes will be made at least two weeks prior to start date.
General Information:
- Training is conducted in Chaska, Minnesota unless otherwise noted.
- Classes start promptly at 9:00 a.m. CST and end at approximately 5:00 p.m. CST.
- Credits purchased with system orders expire after the warranty period (approximately one year from date of shipment).
- Prices for all courses include training materials.
- Instruction of classes is presented in English.
